| 1. Define the application and operating conditions | Specify loads, speed, duty cycle, shock or vibration, operating temperature, lubrication, contamination, and required service life. Identify whether the load is mainly radial, axial, or combined. | A completed application questionnaire, operating-condition summary, and documented design assumptions for any proposed bearing calculation. | Non-standard dimensions alone do not establish suitability. Operating conditions affect bearing type, internal design, lubrication, clearances, and expected performance. |
| 2. Control the drawing and interface dimensions | Define bore, outside diameter, width, shoulder dimensions, fits, runout, chamfers, mounting features, and any special geometry. State units, datum references, and revision level. | A controlled drawing with tolerances, a revision history, and a dimensional inspection report for agreed critical characteristics. | Clear, revision-controlled specifications reduce ambiguity between the bearing, shaft, housing, and mating components. |
| 3. Verify material and heat-treatment requirements | Specify the required material grade and condition for rings, rolling elements, and cage where relevant. Confirm hardness range, heat-treatment requirements, and any corrosion-resistance needs. | Material test certificates traceable to the supplied lot, heat-treatment records, and hardness results where these are part of the approved specification. | Material and heat treatment influence fatigue resistance, hardness, dimensional stability, and suitability for the operating environment. Equivalent grades should be approved rather than assumed. |
| 4. Evaluate manufacturing and inspection controls | Review controls for machining, grinding, cleanliness, assembly, lubrication, and protection against contamination. Agree on inspection methods and acceptance criteria before production. | A quality-control plan, sample inspection report, lot identification method, and documented process for handling nonconforming parts. | Special dimensions may require dedicated tooling or inspection methods. Agreed controls help ensure repeatability from sample approval through production lots. |
| 5. Confirm performance calculations and validation | Ask how load capacity, speed limits, fit, clearance, lubrication, and temperature have been assessed for the actual design. Identify any prototype or application testing needed. | Calculation assumptions and results, test plan or test report when applicable, and written confirmation of the design configuration being assessed. | Standardized calculation methods, such as those described in ISO 281 for rolling-bearing load ratings and rating life, may support evaluation when applicable; they do not replace application-specific validation. |
| 6. Check market and application compliance | Identify the destination market and any applicable requirements for the complete product or its components, including chemical-substance restrictions, declarations, and customer-specific rules. | Relevant declarations or test documentation for the specified material and product configuration. For example, assess REACH or RoHS requirements only where they apply to the product, market, and intended use. | Compliance obligations depend on jurisdiction, product category, and application. A general quality-system certificate, such as ISO 9001 certification, is not by itself proof that a specific bearing meets every legal or customer requirement. |
| 7. Agree on traceability, packaging, and change control | Set lot and serial identification needs, preservation method, packaging, storage conditions, delivery quantities, lead-time assumptions, and approval requirements for changes to materials or processes. | A purchase specification covering traceability and packaging, sample labels or records, and a written change-notification and approval process. | Traceability supports investigation of quality issues, while suitable packaging and controlled changes help protect parts and maintain consistency during storage, transport, and repeat orders. |