| Microporous polyethylene (PE) separator | Approximately 9–20 μm thick; porous, heat-sensitive film | About 10–25 N/m of web width; begin at the low end and adjust for stable tracking | Approximately 30–100 m/min for controlled production; higher speeds require proven web stability | Low to medium: roughly 20,000–60,000 linear meters per shift, depending on uptime and changeovers | Closed-loop tension control, low-inertia unwinding, precise edge guiding, and gentle winding pressure | Check for stretching, wrinkles, edge damage, and tension variation across the roll |
| Microporous polypropylene (PP) separator | Approximately 12–25 μm thick; commonly stiffer than thin PE film | About 15–35 N/m of web width; confirm the material supplier’s limits | Approximately 40–120 m/min, subject to slit quality and roll build | Medium: around 40,000–80,000 linear meters per shift under stable operating conditions | Servo-driven unwind and rewind, adjustable tension zones, and a stable knife holder | Inspect for burrs, dust, edge waviness, and telescoping on finished rolls |
| Multilayer PP/PE/PP separator | Typically about 12–25 μm; layered construction with different shrink and stiffness behavior | About 15–30 N/m of web width; avoid abrupt tension changes between zones | Approximately 30–100 m/min during qualification; increase only after confirming layer integrity | Low to medium: prioritize consistent quality over maximum line speed | Independent unwind and rewind tension zones, responsive load-cell feedback, and controlled acceleration | Check for layer separation, wrinkles, uneven shrinkage, and consistent slit width |
| Ceramic-coated battery separator | Polyolefin base film with a thin ceramic coating; coating formulation and thickness vary | About 10–25 N/m of web width; use low, stable tension to protect the coating | Approximately 20–80 m/min, depending on coating adhesion and edge quality requirements | Low to medium: speed should be limited by coating integrity and inspection requirements | Low-tension control, clean material handling, accurate guiding, and dust extraction where appropriate | Inspect for coating cracks, flakes, contamination, and damage at the slit edge |
| Thicker or reinforced porous membrane | Approximately 25–100 μm or more; actual stiffness depends on polymer and reinforcement | About 25–60 N/m of web width; establish the range using trial rolls | Approximately 40–150 m/min for many stable, heavier webs | Medium to high: select capacity based on required finished-roll volume and changeover time | Higher-capacity drive system, programmable tension recipes, and rewind control matched to roll diameter | Check for web wander, uneven winding hardness, edge quality, and roll-core alignment |